Show simple item record

dc.contributor.authorI. W. Park
dc.contributor.authorD. A. Dornfeld
dc.date.accessioned2017-05-09T00:02:34Z
dc.date.available2017-05-09T00:02:34Z
dc.date.copyrightApril, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27007#221_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123783
dc.description.abstractA finite element model of orthogonal metal cutting including burr formation is presented. A metal-cutting simulation procedure based on a ductile failure criterion is proposed for the purpose of better understanding the burr formation mechanism and obtaining a quantitative analysis of burrs using the finite element method. In this study, the four stages of burr formation, i.e., initiation, initial development, pivoting point, and final development stages, are investigated based on the stress and strain contours with the progressive change of geometry at the edge of the workpiece. Also, the characteristics of thick and thin burrs are clarified along with the negative deformation zone formed in front of the tool edge in the final development stage. [S0094-4289(00)00702-7]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study of Burr Formation Processes Using the Finite Element Method: Part I
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.482791
dc.journal.fristpage221
dc.journal.lastpage228
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsMetal cutting
dc.keywordsSimulation
dc.keywordsFinite element methods
dc.keywordsFinite element analysis
dc.keywordsCutting
dc.keywordsFailure
dc.keywordsFinite element model
dc.keywordsMechanisms
dc.keywordsStress
dc.keywordsSteady state AND Geometry
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record