Show simple item record

dc.contributor.authorL. E. Govaert
dc.contributor.authorP. H. M. Timmermans
dc.contributor.authorW. A. M. Brekelmans
dc.date.accessioned2017-05-09T00:02:33Z
dc.date.available2017-05-09T00:02:33Z
dc.date.copyrightApril, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27007#177_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123775
dc.description.abstractIntrinsic strain softening appears to be the main cause for the occurrence of plastic localization phenomena in deformation of glassy polymers. This is supported by the homogeneous plastic deformation behavior that is observed in polycarbonate samples that have been mechanically pretreated to remove (saturate) the strain softening effect. In this study, some experimental results are presented and a numerical analysis is performed simulating the effect of mechanical conditioning by cyclic torsion on the subsequent deformation of polycarbonate. To facilitate the numerical analysis of the “mechanical rejuvenation” effect, a previously developed model, the “compressible Leonov model,” is extended to describe the phenomenological aspects of the large strain mechanical behavior of glassy polymers. The model covers common observable features, like strain rate, temperature and pressure dependent yield, and the subsequent strain softening and strain-hardening phenomena. The model, as presented in this study, is purely “single mode” (i.e., only one relaxation time is involved), and therefore it is not possible to capture the nonlinear viscoelastic pre-yield behavior accurately. The attention is particularly focused on the large strain phenomena. From the simulations it becomes clear that the preconditioning treatment removes the intrinsic softening effect, which leads to a more stable mode of deformation. [S0094-4289(00)01002-1]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Influence of Intrinsic Strain Softening on Strain Localization in Polycarbonate: Modeling and Experimental Validation
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.482784
dc.journal.fristpage177
dc.journal.lastpage185
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsTemperature
dc.keywordsStress
dc.keywordsTorsion
dc.keywordsModeling
dc.keywordsWork hardening
dc.keywordsEngineering simulation
dc.keywordsCompression AND Polymers
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record