Show simple item record

dc.contributor.authorSaiganesh K. Iyer
dc.contributor.authorCliff J. Lissenden
dc.date.accessioned2017-05-09T00:02:33Z
dc.date.available2017-05-09T00:02:33Z
dc.date.copyrightJuly, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27009#321_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123762
dc.description.abstractA generalized threshold function for viscoplastic materials, which can also serve as a yield function in rate-independent plasticity, is suggested for materials that exhibit a strength differential and/or a permanent volume change. The motivation for this type of a threshold function is that experiments, at both 25 and 650°C, on the nickel-based alloy Inconel 718 indicate that higher stresses occur in compression than in tension. Similar results have been obtained for martensitic steels and other metallic alloys at 25°C. A general approach for determining the inelastic flow dependence on each of the three stress invariants (I1,J2, and J3) is to follow stress paths where only one invariant is changing. Two classical experiments that do this are hydrostatic pressure and pure torsion, however many others are possible. Unfortunately, these stress paths generally require three-dimensional stress states, which are difficult to obtain in the laboratory. Thus, for experimental expediency, tests involving axial-torsional loading of thin-walled tubes can be used to determine the significance of the first and third stress invariants, I1 and J3, respectively. [S0094-4289(00)01303-7]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInelastic Anisotropy of Inconel 718: Experiments and Mathematical Representation
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.482804
dc.journal.fristpage321
dc.journal.lastpage326
dc.identifier.eissn1528-8889
dc.keywordsFlow (Dynamics)
dc.keywordsStress
dc.keywordsCompression
dc.keywordsTension
dc.keywordsAnisotropy
dc.keywordsNickel
dc.keywordsAlloys
dc.keywordsPlasticity AND Martensitic steel
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record