• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Numerical Simulation of a Heat-Treated Ring Gear Blank

    Thumbnail
    View/Open
    JEMTA8-27009#305_1.pdf (973.7Kb)
    Date
    2000
    Author
    C. Mgbokwere
    M. Callabresi
    Metadata
    Show full item record
    Abstract
    Carburization and quenching of steels in general has been and continues to be an important commercial manufacturing process for steel components. The minimization of distortion, cracking, and residual stresses are major issues that need to be properly understood in order to efficiently produce high quality components. To assist process engineers in understanding the effect process parameters have on these major issues, a numerical study was conducted on an automotive transmission ring gear. The ring gear has substantial ovaling distortion, which cannot always be straightened within the design tolerances of the part thereby leading to a 3–5 percent rejection rate. The purpose of this report is to predict the distortions, microstructural phase changes, residual stresses, and hardness that occur during quenching using finite element techniques. The ABAQUS model from the NCMS Heat Treatment Prediction Program was used to perform the simulations. This report describes a two-dimensional simulation of the gear blank with the wall thinned where the teeth would have been located to represent the proper thermal mass. The gear blank geometry is essentially the same as the gear geometry without the teeth; moreover it has the same dimensions exhibited by the gear. Even though the ovaling caused by distortion is a three-dimensional problem the two-dimensional representation was chosen as an initial step before simulating the more complex three-dimensional gear geometry. The symmetry of the blank can be exploited by allowing fewer elements to be used for the finite element analysis which in turn will decrease the simulation times of the problem. [S0094-4289(00)01103-8]
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/123760
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV