Show simple item record

dc.contributor.authorAbdulghani A. Al-Farayedhi
dc.contributor.authorA. M. Al-Dawood
dc.contributor.authorP. Gandhidasan
dc.date.accessioned2017-05-09T00:02:15Z
dc.date.available2017-05-09T00:02:15Z
dc.date.copyrightDecember, 2000
dc.date.issued2000
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26492#239_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123593
dc.description.abstractThe current paper examines the effects of using MTBE as a replacement of lead additives in gasoline on exhaust emissions of a typical SI engine. The MTBE was blended with a base unleaded fuel in three ratios (10, 15, and 20 vol. percent). The emissions of CO, HC, and NOx were measured at a variety of engine operating conditions using an engine dynamometer setup. The results of the MTBE blends were compared to those of the base fuel and of a leaded fuel prepared by adding TEL to the base. With respect to the base fuel, the addition of MTBE decreased the CO emissions, decreased the HC emissions at most operating conditions, but generally increased the NOx emissions. The emissions results for the leaded fuel were comparable to those of the base fuel. [S0195-0738(00)00103-5]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Blending MTBE With Unleaded Gasoline on Exhaust Emissions of SI Engine
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.1288206
dc.journal.fristpage239
dc.journal.lastpage247
dc.identifier.eissn1528-8994
dc.keywordsFuels
dc.keywordsMTBE
dc.keywordsExhaust systems
dc.keywordsEmissions
dc.keywordsNitrogen oxides
dc.keywordsEngines
dc.keywordsGasoline
dc.keywordsStress
dc.keywordsSpark-ignition engine AND Temperature
dc.treeJournal of Energy Resources Technology:;2000:;volume( 122 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record