Show simple item record

dc.contributor.authorAles Hribernik
dc.contributor.authorJohn J. Moskwa
dc.date.accessioned2017-05-09T00:02:01Z
dc.date.available2017-05-09T00:02:01Z
dc.date.copyrightSeptember, 2000
dc.date.issued2000
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26270#483_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123455
dc.description.abstractTo examine the influence of intercooler thermal inertia on transient engine operation, a 2D model of an air-to-air, cross-flow heat exchanger has been developed. Finned passages of heat exchanger core have been subdivided into separate channels of charge and cooling air, respectively. A two-step Lax-Wendroff differential method has been used to solve one-dimensional, nonhomentropic, unsteady, compressible fluid flow in each channel. Simultaneously, the Saul’yev explicit method has been applied to compute the 2D temperature distribution along the dividing plate. The Wieting correlation has been used to compute the local convection heat transfer coefficient and friction factor. The model has been verified against steady-state experimental data and then incorporated into an engine cycle simulation program based on “Filling-Emptying” method. Two engine transients have been simulated; the acceleration of the engine from idle to rated engine speed at constant load, and deceleration from rated power to rated torque by increasing the load torque. The first example shows the warming up of the intercooler, while in the second example intercooler temperatures are decreasing. The results have been compared with the predictions of an additional set of simulations, where the NTU-effectiveness method has been used to simulate the intercooler, and the thermal inertia of intercooler has been neglected. The results of both sets of simulations are discussed in the paper. [S0022-0434(00)02003-7]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTransient Response of a Cross-Flow Charge Air Intercooler and Its Influence on Engine Operation
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.1286683
dc.journal.fristpage483
dc.journal.lastpage489
dc.identifier.eissn1528-9028
dc.keywordsTemperature
dc.keywordsCooling
dc.keywordsChannels (Hydraulic engineering)
dc.keywordsEngines
dc.keywordsTransients (Dynamics)
dc.keywordsHeat exchangers
dc.keywordsSteady state
dc.keywordsCross-flow
dc.keywordsTorque
dc.keywordsStress
dc.keywordsFlow (Dynamics)
dc.keywordsInertia (Mechanics) AND Convection
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2000:;volume( 122 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record