Show simple item record

dc.contributor.authorM. Paulino
dc.contributor.authorP. Izquierdo
dc.contributor.authorJ. Antunes
dc.date.accessioned2017-05-09T00:00:44Z
dc.date.available2017-05-09T00:00:44Z
dc.date.copyrightFebruary, 1999
dc.date.issued1999
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28389#61_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122760
dc.description.abstractImpact forces are useful information in field monitoring of many industrial components, such as heat exchangers, condensers, etc. In two previous papers we presented techniques—based on vibratory measurements remote from the actual impact locations—for the experimental identification of isolated impacts (Araújo et al., 1996) and complex rattling forces (Antunes et al., 1997). In both papers a single gap support was assumed. Those results concern systems which are simpler than the actual multi-supported tube bundles found in heat exchangers. Impact force identification is a difficult problem for such systems, because 1) when sensed by the remote motion transducers, the traveling waves generated at several impact supports are mixed, and there is no obvious way to isolate the contribution of each support; 2) multi-supported tubes may be quite long, with significant dissipative effects (by interacting flows or by frictional phenomena at the clearance supports), leading to some loss of the information carried by the traveling waves; 3) in multi-supported systems, some of the supports are often in permanent contact, leading to nonimpulsive forces which are difficult to identify. In this paper, we move closer towards force identification under realistic conditions. Only the first problem of wave isolation is addressed, assuming that damping effects are small and also that all clearance supports are impacting. An iterative multiple-identification method is introduced, which operates in an alternate fashion between the time and frequency domains. This technique proved to be effective in isolating the impact forces generated at each gap support. Experiments were performed on a long beam with three clearance supports, excited by random forces. Beam motions were planar, with complex rattling at the supports. Experimental results are quite satisfactory, as the identified impact forces compare favorably with the direct measurements.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRemote Identification of Impact Forces on Loosely Supported Tubes: Analysis of Multi-Supported Systems
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2883668
dc.journal.fristpage61
dc.journal.lastpage70
dc.identifier.eissn1528-8978
dc.keywordsForce
dc.keywordsWaves
dc.keywordsClearances (Engineering)
dc.keywordsHeat exchangers
dc.keywordsMeasurement
dc.keywordsMotion
dc.keywordsTravel
dc.keywordsFlow (Dynamics)
dc.keywordsTransducers
dc.keywordsCondensers (steam plant) AND Damping
dc.treeJournal of Pressure Vessel Technology:;1999:;volume( 121 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record