Show simple item record

dc.contributor.authorD. P. Jones
dc.contributor.authorJ. E. Holliday
dc.contributor.authorL. D. Larson
dc.date.accessioned2017-05-09T00:00:41Z
dc.date.available2017-05-09T00:00:41Z
dc.date.copyrightMay, 1999
dc.date.issued1999
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28391#149_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122736
dc.description.abstractThis paper provides a comparison between test and analysis results for bursting of thin toroidal shells. Testing was done by pressurizing two toroidal shells until failure by bursting. An analytical criterion for bursting is developed based on good agreement between structural instability predicted by large strain-large displacement elastic-plastic finite element analysis and observed burst pressure obtained from test. The failures were characterized by loss of local stability of the membrane section of the shells consistent with the predictions from the finite element analysis. Good agreement between measured and predicted burst pressure suggests that incipient structural instability as calculated by an elastic-plastic finite element analysis is a reasonable way to calculate the bursting pressure of thin membrane structures.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleElastic-Plastic Failure Analysis of Pressure Burst Tests of Thin Toroidal Shells
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2883678
dc.journal.fristpage149
dc.journal.lastpage153
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsFailure analysis
dc.keywordsShells
dc.keywordsFinite element analysis
dc.keywordsFailure
dc.keywordsMembranes
dc.keywordsTesting
dc.keywordsDisplacement AND Stability
dc.treeJournal of Pressure Vessel Technology:;1999:;volume( 121 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record