Show simple item record

dc.contributor.authorD. P. Jones
dc.contributor.authorT. R. Leax
dc.date.accessioned2017-05-09T00:00:39Z
dc.date.available2017-05-09T00:00:39Z
dc.date.copyrightAugust, 1999
dc.date.issued1999
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28392#269_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122718
dc.description.abstractFatigue crack growth tests were performed on four-point bend specimens with cracklike defects intentionally placed in A302B low-alloy pressure vessel steel clad with 308/309L weld-deposited stainless steel. The defects were placed in the base metal under the cladding by machining a cavity from the side opposite the cladding, electric-discharge machining a very sharp flaw, fatigue precracking the flaw, and then filling up the cavity by a weld repair process. The specimens were stress relieved before fatigue testing. The specimens were fatigue cycled at positive load ratios until the defects broke through to the surface. The specimens were then fractured at liquid nitrogen temperatures to reveal the fracture surfaces. Seven different sub-clad flaw specimens were tested in room temperature air and each test provides a record of cycles to defect breakthrough. Changes in defect size and shape as a function of applied load cycles were obtained by beach-marking the crack at various stages of the load history. The results provide a set of embedded defect data which can be used for qualifying fatigue crack growth analysis procedures such as those in Section XI of the ASME Boiler and Pressure Vessel Code. A comparison between calculated and measured values shows that the ASME B&PV Section XI fatigue crack growth procedures conservatively predict cycles to defect breakthrough for small sub-clad defects.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Crack Growth Testing of Sub-Clad Defects
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2883702
dc.journal.fristpage269
dc.journal.lastpage275
dc.identifier.eissn1528-8978
dc.keywordsProduct quality
dc.keywordsTesting
dc.keywordsFatigue cracks
dc.keywordsStress
dc.keywordsCycles
dc.keywordsCavities
dc.keywordsCladding systems (Building)
dc.keywordsFatigue
dc.keywordsTemperature
dc.keywordsMachining
dc.keywordsAlloys
dc.keywordsSteel
dc.keywordsMaintenance
dc.keywordsElectric discharge
dc.keywordsPressure vessels
dc.keywordsFracture (Process)
dc.keywordsBase metals
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsFatigue testing
dc.keywordsNitrogen
dc.keywordsShapes AND Stainless steel
dc.treeJournal of Pressure Vessel Technology:;1999:;volume( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record