Show simple item record

dc.contributor.authorC. S. Sloan
dc.contributor.authorM. D. Cowell
dc.contributor.authorT. F. Lehnhoff
dc.date.accessioned2017-05-09T00:00:39Z
dc.date.available2017-05-09T00:00:39Z
dc.date.copyrightAugust, 1999
dc.date.issued1999
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28392#252_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122716
dc.description.abstractStress concentration factors have been determined for large hole to small hole diameter ratios (D/d) of 10 to 50 for two holes in an infinitely wide tension-loaded panel. Finite element analysis was used to model the system of two holes in a plate that approximates the infinitely wide and tall case. Both the D/d ratio and edge to edge hole spacing were examined for hole placement along an axis perpendicular to the direction of the tension field. It was found for large D/d ratios that the stress concentration factor was only dependent on the distance between the hole edges divided by the large hole diameter. For the configurations analyzed, the stress concentration factors varied from approximately 3 to 11.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of a Large Hole on the Stress Concentration Factor of a Satellite Hole in a Tension Field
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2883700
dc.journal.fristpage252
dc.journal.lastpage256
dc.identifier.eissn1528-8978
dc.keywordsStress concentration
dc.keywordsTension
dc.keywordsSatellites AND Finite element analysis
dc.treeJournal of Pressure Vessel Technology:;1999:;volume( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record