Show simple item record

dc.contributor.authorJung H. Ahn
dc.contributor.authorAnthony M. Waas
dc.date.accessioned2017-05-08T23:59:47Z
dc.date.available2017-05-08T23:59:47Z
dc.date.copyrightJuly, 1999
dc.date.issued1999
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26999#360_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122230
dc.description.abstractA micromechanics based failure initiation predictive capability for analyzing notched composite laminates loaded remotely in multiaxial compression is reported. The model relies on the results from a previous experimental study that investigated compression failure mechanisms in special “uniply” composite laminates. The finite element method (FEM) was used in the solution process. The experimental results showed that the dominant mode of failure initiation was kink banding near the hole edge. The kink band was confined in extent to a distance within one half of the hole radius. The fibers within the kink band were rotated both in plane and out of the plane of the laminate. The position of the kink band with respect to the center of the notch depended on the remote biaxial load ration. In the FEM, the region in which kink banding takes place is contained within a finite size rectangular area, and is meshed as an alternatingly stacked region of fiber and matrix layers. The values of boundary loads on this rectangular area which correspond to kink banding is related to the remotely applied loads via an available closed form analysis for orthotropic laminates. Good agreement is found between experiment and analysis for a wide range of notch sizes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Micromechanics-Based Finite Element Model for Compressive Failure of Notched Uniply Composite Laminates Under Remote Biaxial Loads
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812387
dc.journal.fristpage360
dc.journal.lastpage366
dc.identifier.eissn1528-8889
dc.keywordsLaminates
dc.keywordsStress
dc.keywordsMicromechanics (Engineering)
dc.keywordsComposite materials
dc.keywordsFailure
dc.keywordsFinite element model
dc.keywordsFibers
dc.keywordsCompression AND Failure mechanisms
dc.treeJournal of Engineering Materials and Technology:;1999:;volume( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record