• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Optimum Forming Loading Paths for Pb-Sn Superplastic Sheet Materials

    Thumbnail
    View/Open
    JEMTA8-26999#341_1.pdf (591.9Kb)
    Date
    1999
    Author
    Marwan K. Khraisheh
    Hussein M. Zbib
    Metadata
    Show full item record
    Abstract
    The bulge forming performance of Pb-Sn superplastic sheet materials is evaluated under different forming pressure-time profiles. In addition, an “optimum” pressure-time profile based on variable strain rates is proposed. Results of forming time, achieved amount of deformation, and thinning behavior are reported for the different forming pressure profiles. Not only the forming time was significantly reduced, when forming with the optimum pressure profile, but the integrity of the formed part was also maintained. Furthermore, the results show that forming profiles based on uniaxial models cannot successfully predict the actual forming behavior when the loading path is biaxial. In fact, the one-dimensional strain rate hardening relation, along with von Mises criterion, predict failure at a much higher strain (time) than the actual case.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/122227
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV