Show simple item record

dc.contributor.authorRobert C. Wetherhold
dc.contributor.authorDionysios E. Mouzakis
dc.date.accessioned2017-05-08T23:59:45Z
dc.date.available2017-05-08T23:59:45Z
dc.date.copyrightOctober, 1999
dc.date.issued1999
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27002#483_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122207
dc.description.abstractThe addition of the low-cost mineral filler kaolin to high-density polyethylene (HDPE) creates a composite with both improved stiffness and toughness properties. This study focuses on two aspects of the toughness of these composites: the fracture toughness increment produced by work at the fracture surface and the directionality induced by the injection molding fabrication process. The Essential Work of Fracture (EWF) method gives results which show that a higher volume fraction of kaolin produces more surface work, consistent with earlier work using Compact Tension (CT) tests. The EWF method also demonstrates that a lower volume fraction can produce a higher overall plastic work and apparent toughness. A heat treatment that removes the orientation of the matrix but not that of the particles was applied to study the effect of matrix crystallinity. The results indicate that the matrix supramolecular structure (crystallinity and skin-core effect) is responsible for the directionality of toughness, and that a heat treatment can be used to produce high toughness behavior in both major directions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFracture Behavior of Kaolin-Reinforced High Density Polyethylene
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812405
dc.journal.fristpage483
dc.journal.lastpage487
dc.identifier.eissn1528-8889
dc.keywordsDensity
dc.keywordsFracture (Process)
dc.keywordsKaolin
dc.keywordsToughness
dc.keywordsHeat treating (Metalworking)
dc.keywordsComposite materials
dc.keywordsParticulate matter
dc.keywordsManufacturing
dc.keywordsFillers (Materials)
dc.keywordsFracture toughness
dc.keywordsSkin
dc.keywordsStiffness
dc.keywordsTension AND Injection molding
dc.treeJournal of Engineering Materials and Technology:;1999:;volume( 121 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record