Show simple item record

dc.contributor.authorM. V. Hosur
dc.contributor.authorU. K. Vaidya
dc.contributor.authorA. Abraham
dc.contributor.authorN. Jadhav
dc.contributor.authorS. Jeelani
dc.date.accessioned2017-05-08T23:59:45Z
dc.date.available2017-05-08T23:59:45Z
dc.date.copyrightOctober, 1999
dc.date.issued1999
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27002#468_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122205
dc.description.abstractFiber reinforced composites, due to their higher specific strength and specific stiffness, are replacing many metallic structures. Of these, thick composite laminates are of high interest in various, millitary, transportation and marine applications for their use in ballistic and shock protection. One such application is in Composite Armored Vehicle (CAV) integral armor comprising of thick section composite that serves as the primary load-bearing component. The current solution of the structural backing laminate utilizes an S2-glass/epoxy system processed using automated fiber placement method. While proven structurally suitable, this method is time consuming as well as expensive. This paper presents several alternative cost-effective manufacturing solutions for fabricating composite laminates of 20 mm (0.8 in.) nominal thickness (made of 45 layer, 2 × 2 twill weave S2-glass with 933 sizing/vinyl ester C-50 resin), consisted with them CAV application in focus. They include Vacuum Assisted Resin Transfer Molding (VARTM) and Vacuum Assisted Resin Infusion Modeling (VARIM) and their variations. The effectiveness of different affordable processing approaches adopted in fabricating the structural laminate is compared in terms of static and dynamic compression response of the laminations. Static studies have been conducted on thick composites using specimen based on Army Material Technology Laboratory’s (AMTL) recommendation for thick section composites, while dynamic response is studied on cubic specimen samples using a Split Hopkinson Pressure Bar (SHPB).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStatic and High Strain Rate Compression Response of Thick Section Twill Weave S-2 Glass/Vinyl Ester Composites Manufactured by Affordable Liquid Molding Processes
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812403
dc.journal.fristpage468
dc.journal.lastpage475
dc.identifier.eissn1528-8889
dc.keywordsComposite materials
dc.keywordsGlass
dc.keywordsTwill
dc.keywordsMolding
dc.keywordsCompression
dc.keywordsEster
dc.keywordsLaminates
dc.keywordsResins
dc.keywordsVacuum
dc.keywordsPressure
dc.keywordsFibers
dc.keywordsManufacturing
dc.keywordsFiber reinforced composites
dc.keywordsStress
dc.keywordsLaminations
dc.keywordsMaterials technology
dc.keywordsDynamic response
dc.keywordsEpoxy adhesives
dc.keywordsShock (Mechanics)
dc.keywordsBearings
dc.keywordsModeling
dc.keywordsTransportation systems
dc.keywordsVehicles
dc.keywordsStiffness
dc.keywordsThickness
dc.keywordsTransfer molding
dc.keywordsArmy AND Armor
dc.treeJournal of Engineering Materials and Technology:;1999:;volume( 121 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record