Show simple item record

dc.contributor.authorA. K. Gupta
dc.contributor.authorT. Hasegawa
dc.contributor.authorS. Bolz
dc.date.accessioned2017-05-08T23:59:26Z
dc.date.available2017-05-08T23:59:26Z
dc.date.copyrightSeptember, 1999
dc.date.issued1999
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26483#209_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/122050
dc.description.abstractThe structure of turbulent diffusion flames with highly preheated combustion air (air preheat temperature in excess of 1150°C) has been obtained using a specially designed regenerative combustion furnace. Propane gas was used as the fuel. Data have been obtained on the global flame features, spectral emission characteristics, spatial distribution of OH, CH, and C2 species, and pollutant emission from the flames. The results have been obtained for various degrees of air preheat temperatures and O2 concentration in the air. The color of the flame was found to change from yellow to blue to bluish-green to green over the range of conditions examined. In some cases a hybrid color flame was also observed. The recorded images of the flame photographs were analyzed using color-analyzing software. The results show that thermal and chemical flame behavior strongly depends on the air preheat temperature and oxygen content in the air. The flame color was observed to be bluish-green or green at very high air preheat temperatures and low-oxygen concentration. However, at high-oxygen concentration, the flame color was yellow. The flame volume was found to increase with increase in air-preheat temperature and decrease in oxygen concentration. The flame length showed a similar behavior. The concentrations of OH, CH, and C2 increased with an increase in air preheat temperatures. These species exhibited a two-stage combustion behavior at low-oxygen concentration and single-stage combustion behavior at high-oxygen concentration in the air. Stable flames were obtained for remarkably low equivalence ratios, which would not be possible with normal combustion air. Pollutant emission, including CO2 and NOx , was much lower with highly preheated combustion air at low O2 concentration than with normal air. The results also suggest uniform flow and flame thermal characteristics with conditioned, highly preheated air. Highly preheated air combustion provides much higher heat flux than normal air, which suggests direct energy savings and a reduction of CO2 to the environment. Colorless oxidation of fuel has been observed under certain conditions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Air Preheat Temperature and Oxygen Concentration on Flame Structure and Emission
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2795984
dc.journal.fristpage209
dc.journal.lastpage216
dc.identifier.eissn1528-8994
dc.keywordsTemperature
dc.keywordsFlames
dc.keywordsOxygen
dc.keywordsEmissions
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsPollution
dc.keywordsFurnaces
dc.keywordsoxidation
dc.keywordsTurbulent diffusion
dc.keywordsComputer software
dc.keywordsHeat flux AND Flow (Dynamics)
dc.treeJournal of Energy Resources Technology:;1999:;volume( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record