Show simple item record

dc.contributor.authorA. S. Cherry
dc.contributor.authorR. P. Jones
dc.contributor.authorT. E. C. Potter
dc.date.accessioned2017-05-08T23:59:14Z
dc.date.available2017-05-08T23:59:14Z
dc.date.copyrightSeptember, 1999
dc.date.issued1999
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26257#479_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121907
dc.description.abstractThis paper describes the use of realistic analytical techniques to address automotive ride control. Multibody system (MBS) modeling techniques were used to develop a full vehicle model with suspension system representation, which was subsequently validated against experimental data. The resultant multivariable ride control problem was then decoupled in the frequency domain by the application of equivalence transformation techniques. It is shown that diagonalization can be achieved for the range of primary ride frequencies, and that the decoupled system then consists of three single-input/single-output (SISO) systems, one for each of the sprung mass modes. Finally, feedback control design for each sprung mass mode loop is illustrated by the application of modal damping.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Use of Multibody System Modeling and Multivariable System Decoupling Techniques in Vehicle Ride Control
dc.typeJournal Paper
dc.journal.volume121
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2802499
dc.journal.fristpage479
dc.journal.lastpage486
dc.identifier.eissn1528-9028
dc.keywordsModeling
dc.keywordsVehicles
dc.keywordsMultibody systems
dc.keywordsSuspension systems
dc.keywordsDamping
dc.keywordsDesign
dc.keywordsFeedback AND Frequency
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1999:;volume( 121 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record