Show simple item record

dc.contributor.authorR. Kumar
dc.date.accessioned2017-05-08T23:57:42Z
dc.date.available2017-05-08T23:57:42Z
dc.date.copyrightFebruary, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28382#81_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121058
dc.description.abstractHeat exchangers, steam generators, and other pressure vessels in nuclear power plants are equipped with bolted closures for the purpose of in-service inspection and maintenance. The ASME Boiler and Pressure Vessel Code specifies that all Class 1 components meet the fatigue life requirements for level A and B service conditions. In the case of bolted closures, it is often found that the bolt/stud is the most critical part. In many situations, the bolts fail to meet the fatigue requirements for the design life of the equipment. In such cases, the bolts can be replaced after certain duration based upon their fatigue life. However, the mating threads in the flange (which is an integral part of the vessel) are still a concern. While the replacement of the bolts is relatively easy and inexpensive, the corrective action (e.g., replacement or repair) for the flange is usually difficult and expensive, or impossible. Hence, it is important to have a reasonable estimate of the fatigue life of internal threads to alleviate or minimize the concern. In this paper, a simplified approach is presented for this purpose. Considering various bolt sizes, commonly used thread series, and typical Class 1 component materials, it is shown that the fatigue life of the internal threads is about three times the fatigue life of the bolt threads. This conclusion greatly reduces or eliminates the concern for in-service replacement or repair of the components with internal threads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Life Estimation for Internal Threads in Class 1 Components
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2841890
dc.journal.fristpage81
dc.journal.lastpage85
dc.identifier.eissn1528-8978
dc.keywordsThread
dc.keywordsFatigue life
dc.keywordsMaintenance
dc.keywordsFlanges
dc.keywordsBoilers
dc.keywordsDesign
dc.keywordsHeat exchangers
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsNuclear power stations
dc.keywordsVessels
dc.keywordsIn-service inspection
dc.keywordsPressure vessels AND Fatigue
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record