Show simple item record

dc.contributor.authorM. A. Shalaby
dc.contributor.authorM. Y. A. Younan
dc.date.accessioned2017-05-08T23:57:41Z
dc.date.available2017-05-08T23:57:41Z
dc.date.copyrightFebruary, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28382#35_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121049
dc.description.abstractThe purpose of this study is to determine limit loads for pipe elbows subjected to in-plane bending moments that tend to close the elbow (i.e., decrease its radius of curvature), and the influence of internal pressure on the value of the limit load. Load-deflection curves were obtained, and from these curves plastic collapse or instability loads at various values of internal pressure were determined. This was done for different pipe bend factors (h = Rt/r2 ) using the nonlinear finite element analysis code (ABAQUS) with its special elbow element. The limit load was found to increase and then decrease with increasing pressure for all the elbow geometries studied.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLimit Loads for Pipe Elbows With Internal Pressure Under In-Plane Closing Bending Moments
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2841882
dc.journal.fristpage35
dc.journal.lastpage42
dc.identifier.eissn1528-8978
dc.keywordsPipes
dc.keywordsPressure
dc.keywordsStress
dc.keywordsFinite element analysis
dc.keywordsCollapse
dc.keywordsDeflection AND Pipe bends
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record