Show simple item record

dc.contributor.authorD. P. Updike
dc.contributor.authorA. Kalnins
dc.date.accessioned2017-05-08T23:57:41Z
dc.date.available2017-05-08T23:57:41Z
dc.date.copyrightFebruary, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28382#6_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121043
dc.description.abstractThis paper examines the calculated pressure at a tensile plastic instability of a pressure vessel and its relationship to burst test results. It is proposed that the instability pressure be accepted as an upper bound to the pressure at which a vessel bursts, and that a strength reduction factor be used to predict the burst. The paper also presents a suitable mathematical model for the calculation of the instability pressures for thin-walled axisymmetric vessels. The proposition is tested by applying the model to a pressurized diaphragm, four cylindrical shells, and two torispherical heads, for which experimental burst data are available. It is found that the ratio of the test burst pressure to the calculated pressure at the tensile plastic instability, expressed in percent, ranges from 71 to 96 percent. The highest ratio occurs for a pressurized diaphragm with no significant defects. The lowest ratios occur for cylindrical shells with longitudinal welds, suggesting that the presence of the welds had a detrimental effect on the burst strength. These results may be useful when designing a pressure vessel with respect to its ultimate strength.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTensile Plastic Instability of Axisymmetric Pressure Vessels
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2841888
dc.journal.fristpage6
dc.journal.lastpage11
dc.identifier.eissn1528-8978
dc.keywordsPressure vessels
dc.keywordsPressure
dc.keywordsPipes
dc.keywordsDiaphragms (Structural)
dc.keywordsWelded joints
dc.keywordsVessels
dc.keywordsDesign
dc.keywordsTensile strength AND Product quality
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record