Show simple item record

dc.contributor.authorM. Allam
dc.contributor.authorA. Chaaban
dc.contributor.authorA. Bazergui
dc.date.accessioned2017-05-08T23:57:40Z
dc.date.available2017-05-08T23:57:40Z
dc.date.copyrightMay, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28384#129_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121029
dc.description.abstractThe knowledge of residual stresses introduced in the tubes of heat exchangers during their expansion in the tubesheet holes is important because of their effect on the structural integrity of components. This paper presents a simplified theoretical method to calculate the maximum residual stresses introduced in the transition zone of expanded tube-to-tubesheet joint. The higher positive values of tensile residual stresses and their corresponding axial locations are determined by using a standard deviation analysis. The validation of the proposed equations was accomplished by comparing their results to those obtained by the finite element method for some arbitrary cases. An upper limit has been imposed on the expansion pressure level, depending on the combination of the geometrical and material parameters that are involved in the design of the tube-to-tubesheet joints.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEstimation of Residual Stresses in Hydraulically Expanded Tube-to-Tubesheet Joints
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842230
dc.journal.fristpage129
dc.journal.lastpage137
dc.identifier.eissn1528-8978
dc.keywordsResidual stresses
dc.keywordsFinite element methods
dc.keywordsDesign
dc.keywordsHeat exchangers
dc.keywordsEquations AND Pressure
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record