Show simple item record

dc.contributor.authorC. E. Taylor
dc.contributor.authorT. J. Dickinson
dc.contributor.authorP. Vidalou
dc.contributor.authorI. G. Currie
dc.contributor.authorM. J. Pettigrew
dc.date.accessioned2017-05-08T23:57:39Z
dc.date.available2017-05-08T23:57:39Z
dc.date.copyrightAugust, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28385#283_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121020
dc.description.abstractHeat exchanger tubes can be damaged or fail if subjected to excessive flow-induced vibration, either from fatigue or fretting-wear. Good heat exchanger design requires that the designer understands and accounts for the vibration mechanisms that might occur, such as vortex shedding, turbulent excitation or fluidelastic instability. To incorporate these phenomena into a flow-induced vibration analysis of a heat exchanger requires information about damping. Damping in multispan heat exchanger tubes largely consists of three components: viscous damping along the tube, and friction and squeeze-film damping at the supports. Unlike viscous damping, squeeze-film damping and friction damping are poorly understood and difficult to measure. In addition, the effect of temperature-dependent fluid viscosity on tube damping has not been verified. To investigate these problems, a single vertical heat exchanger tube with multiple spans was excited by random vibration. Tests were conducted in air and in water at three different temperatures (25, 60, and 90°C). At room temperature, tests were carried out at five different preloads. Frequency response spectra and resonant peak-fitted damping ratios were calculated for all tests. Energy dissipation rates at the supports and the rate of excitation energy input were also measured. Results indicate that damping does not change over the range of temperatures tested and friction damping is very dependent on preload.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleVibration Damping in Multispan Heat Exchanger Tubes
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842059
dc.journal.fristpage283
dc.journal.lastpage289
dc.identifier.eissn1528-8978
dc.keywordsDamping
dc.keywordsHeat exchangers
dc.keywordsVibration
dc.keywordsTemperature
dc.keywordsFriction
dc.keywordsFlow-induced vibrations
dc.keywordsFatigue
dc.keywordsRandom vibration
dc.keywordsArches
dc.keywordsFrequency response
dc.keywordsWater
dc.keywordsVortex shedding
dc.keywordsMechanisms
dc.keywordsWear
dc.keywordsDesign
dc.keywordsSpectra (Spectroscopy)
dc.keywordsFluids
dc.keywordsTurbulence
dc.keywordsViscosity AND Energy dissipation
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record