Show simple item record

dc.contributor.authorR. W. Motriuk
dc.contributor.authorD. P. Harvey
dc.date.accessioned2017-05-08T23:57:39Z
dc.date.available2017-05-08T23:57:39Z
dc.date.copyrightAugust, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28385#276_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121019
dc.description.abstractHigh-frequency pulsation generated by centrifugal compressors, with pressure wavelengths much smaller than the attached pipe diameter, can cause fatigue failures of the compressor internals, impair compressor performance, and damage the attached compressor piping. There are numerous sources producing pulsation in centrifugal compressors. Some of them are discussed in literature at large (Japikse, 1995; Niese, 1976). NGTL has experienced extreme high-frequency discharge pulsation and pipe wall vibration on many of its radial inlet high-flow centrifugal gas compressor facilities. These pulsations led to several piping attachment failures and compressor internal component failures while the compressor operated within the design envelope. This paper considers severe pulsation conditions at an NGTL compression facility which resulted in unacceptable piping vibration. Significant vibration attenuation was achieved by modifying the compressor (pulsation source) through removal of the diffuser vanes and partial removal of the inlet guide vanes (IGV). Direct comparison of the changes in vibration, pulsation, and performance are made for each of the modifications. The vibration problem, probable causes, options available to address the problem, and the results of implementation are reviewed. The effects of diffuser vane removal on discharge pipe wall vibration as well as changes in compressor performance are described.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCentrifugal Compressor Modifications and Their Effect on High-Frequency Pipe Wall Vibration
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842058
dc.journal.fristpage276
dc.journal.lastpage282
dc.identifier.eissn1528-8978
dc.keywordsCompressors
dc.keywordsPipes
dc.keywordsVibration
dc.keywordsDiffusers
dc.keywordsFailure
dc.keywordsFatigue failure
dc.keywordsDesign
dc.keywordsCompression
dc.keywordsGas compressors
dc.keywordsPressure
dc.keywordsFlow (Dynamics) AND Wavelength
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record