Show simple item record

dc.contributor.authorV. Koundy
dc.contributor.authorM. Delhaye
dc.contributor.authorL. Allais
dc.date.accessioned2017-05-08T23:57:39Z
dc.date.available2017-05-08T23:57:39Z
dc.date.copyrightAugust, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28385#262_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121017
dc.description.abstractThe high-temperature design codes are presently considering the use of stress reduction factors for designing welded structures submitted to creep. These reduction factors are derived from creep tests which are generally made on small specimens and are not necessarily representative of large-size geometries. These codes are very likely overconservative, consequently uneconomical and need to be improved; an investigation to assess and quantify the supposed size effect is required. This paper presents an experimental and numerical study on creep behavior at 600°C of full-size welded joints taking into account real full-thickness of weldings. The material investigated is the austenitic stainless steel 316L(N) with manual metal arc welds using the 19 Cr 12 Ni 2 Mo electrode grade. The creep laws used in calculations are those obtained from tests using small specimens, but some coefficients of their theoretical formulation have been modified to obtain a better coherence with fullsize specimen data. Between small and large full-size specimens, experimental results show no significant difference in time to rupture, and the same location of fracture, at the center of the weldment, is observed. Finite element simulations performed for full-size welded joints provide rupture times that are consistent with measured values. The calculated percentage of the damaged volume in the weld metal as a function of load levels and of creep-time duration is studied; it shows that the creep-rupture times for high stress loading are determined with higher accuracy than for low stress loading.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCreep Behavior of a Large Full-Size Welded Austenitic Steel Plate
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842056
dc.journal.fristpage262
dc.journal.lastpage269
dc.identifier.eissn1528-8978
dc.keywordsSteel
dc.keywordsCreep
dc.keywordsStress
dc.keywordsWelded joints
dc.keywordsRupture
dc.keywordsMetals
dc.keywordsDesign
dc.keywordsElectrodes
dc.keywordsEngineering simulation
dc.keywordsFinite element analysis
dc.keywordsFracture (Process)
dc.keywordsSize effect
dc.keywordsStainless steel
dc.keywordsThickness AND High temperature
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record