Show simple item record

dc.contributor.authorJ. Zheng
dc.date.accessioned2017-05-08T23:57:38Z
dc.date.available2017-05-08T23:57:38Z
dc.date.copyrightAugust, 1998
dc.date.issued1998
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28385#252_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/121015
dc.description.abstractIt has been observed that the degree of contact between layers and the residual stresses caused by pre-tension winding of ribbons does not influence bursting pressure of flat steel ribbon-wound pressure vessels. This suggests the idea that the desirable design criteria for vessels of this type should be based on bursting failure mode, i.e., wall thickness should be determined by bursting pressure which is strongly influenced by friction between layers and laminar effects. It is shown that the probability of bursting failure of vessel for which the bursting pressure is not less than 2.5 design pressure is less than 10−10 . An example demonstrates that a design procedure based on this information not only has significant economic advantages, but also can indicate bursting probability.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNew Method for Design of Flat Steel Ribbon-Wound Pressure Vessels
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842054
dc.journal.fristpage252
dc.journal.lastpage255
dc.identifier.eissn1528-8978
dc.keywordsSteel
dc.keywordsPressure vessels
dc.keywordsDesign
dc.keywordsPressure
dc.keywordsFailure
dc.keywordsProbability
dc.keywordsVessels
dc.keywordsWall thickness
dc.keywordsWinding (process)
dc.keywordsTension
dc.keywordsFriction AND Residual stresses
dc.treeJournal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record