| dc.contributor.author | N. Miura | |
| dc.contributor.author | G. M. Wilkowski | |
| dc.date.accessioned | 2017-05-08T23:57:36Z | |
| dc.date.available | 2017-05-08T23:57:36Z | |
| dc.date.copyright | November, 1998 | |
| dc.date.issued | 1998 | |
| dc.identifier.issn | 0094-9930 | |
| dc.identifier.other | JPVTAS-28387#412_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/120998 | |
| dc.description.abstract | In Part I (Miura and Wilkowski, 1998) of this paper, the theory of the two η-factor solutions for circumferentially through-wall-cracked pipes subjected to combined bending and tension due to internal pressure was presented. These solutions seemed to give reasonable predictions by comparing with the existing simplified J -estimation scheme. It was also ascertained that the J would be underestimated if the effect of the internal pressure was not properly considered. Consequently, this paper presents the application of these solutions to full-scale pipe tests. The tests were performed at 288°C (550°F) under combined bending and internal pressure. The materials used for the tests were both carbon steel and stainless steel. The effect of combined loading on the J-R curves was determined and compared to C(T) specimen J-R curves. The solutions were then verified by using three-dimensional finite element analysis. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | J-R Curves From Circumferentially Through-Wall-Cracked Pipe Tests Subjected to Combined Bending and Tension—Part II: Experimental and Analytical Validation | |
| dc.type | Journal Paper | |
| dc.journal.volume | 120 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Pressure Vessel Technology | |
| dc.identifier.doi | 10.1115/1.2842352 | |
| dc.journal.fristpage | 412 | |
| dc.journal.lastpage | 417 | |
| dc.identifier.eissn | 1528-8978 | |
| dc.keywords | Pipes | |
| dc.keywords | Tension | |
| dc.keywords | Pressure | |
| dc.keywords | Carbon steel | |
| dc.keywords | Finite element analysis AND Stainless steel | |
| dc.tree | Journal of Pressure Vessel Technology:;1998:;volume( 120 ):;issue: 004 | |
| dc.contenttype | Fulltext | |