Show simple item record

dc.contributor.authorS. K. Esche
dc.contributor.authorR. Shivpuri
dc.date.accessioned2017-05-08T23:56:48Z
dc.date.available2017-05-08T23:56:48Z
dc.date.copyrightApril, 1998
dc.date.issued1998
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26991#177_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120537
dc.description.abstractA review of some existing criteria for diffuse necking in sheet metals is given and their limitations are discussed. The introduction into production of new sheet materials whose plastic deformation is impossible to be modeled using Hill’s 1948 anisotropic yield function necessitates improvements of these existing criteria to accurately describe their necking behavior. In this paper, a generalization of the existing diffuse necking criteria for materials describable by Case IV of Hill’s 1979 anisotropic yield function is presented. The proposed criterion is consistent with the previous criteria. It predicts a significant effect of Hill’s 1979 yield surface shape factor on the critical principal strain in the range of negative minor strains while in the range of biaxial tension this influence is small.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Consistent Criterion for Diffuse Necking in Sheet Metals Using Hill’s 1979 Yield Surface
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2807008
dc.journal.fristpage177
dc.journal.lastpage182
dc.identifier.eissn1528-8889
dc.keywordsSheet metal
dc.keywordsNecking
dc.keywordsShapes
dc.keywordsSheet materials
dc.keywordsTension AND Deformation
dc.treeJournal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record