Show simple item record

dc.contributor.authorL. Bertini
dc.contributor.authorV. Fontanari
dc.contributor.authorG. Straffelini
dc.date.accessioned2017-05-08T23:56:45Z
dc.date.available2017-05-08T23:56:45Z
dc.date.copyrightJuly, 1998
dc.date.issued1998
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26992#248_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120520
dc.description.abstractSintered materials show a different stress-strain behavior when subjected to tensile or compressive loading, the response to compression being characterized by a higher elastic modulus, yield stress, and strain hardening rate. These differences tend to make the bending behavior somewhat more complex to analyze, particularly in the elasto-plastic field, as compared to conventional materials, having equal mechanical properties under tension and compression. As a consequence, the use of widely applied test techniques, such as the Three Point Bending (TPB), becomes more difficult for sintered materials, due to the lack of reliable analytical models capable of evaluating elasto-plastic stress-strain distribution as a function of applied load and deflection. In the present investigation, the results of uniaxial tensile-compressive and bending tests conducted on sintered ferrous alloys characterized by different microstructures and porosity are reported and briefly discussed. Then an analytical model, specifically aimed to analyze the elasto-plastic monotonic behavior of a TPB specimen made with a material having different tensile and compressive properties, is presented. Its predictions as regards load-deflection curves and elasto-plastic stress-strain distributions are compared with the results of TPB tests and of numerical (Finite Element) analysis, showing a fairly good agreement.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTensile and Bending Behavior of Sintered Alloys: Experimental Results and Modeling
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812351
dc.journal.fristpage248
dc.journal.lastpage255
dc.identifier.eissn1528-8889
dc.keywordsModeling
dc.keywordsAlloys
dc.keywordsStress
dc.keywordsCompression
dc.keywordsDeflection
dc.keywordsElastic moduli
dc.keywordsPorosity
dc.keywordsTension
dc.keywordsWork hardening
dc.keywordsYield stress
dc.keywordsMechanical properties AND Finite element analysis
dc.treeJournal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record