Show simple item record

dc.contributor.authorP. Kaszynski
dc.contributor.authorE. Ghorbel
dc.contributor.authorD. Marquis
dc.date.accessioned2017-05-08T23:56:44Z
dc.date.available2017-05-08T23:56:44Z
dc.date.copyrightJuly, 1998
dc.date.issued1998
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26992#218_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120515
dc.description.abstractThis paper deals with fatigue problems of 316L stainless-steel surgical structures used in the correction of pelvic obliquity. The structures consist of implants, milled rods, and screws. SEM observations show that fatigue degradation of the elements in complete contact under shearing forces is governed by blunting of the rod pyramid. This involves the occurrence of a micro-clearance at joints leading excessive damage of the junctions. An experimental procedure based on cyclic indentation tests is developed to predict the life of the prosthesis. Results indicate that components exhibit ratchetting. The progressive deformation associated with this phenomenon increases linearly with the logarithm of the number of cycles and leads to the degradation of the surgical assemblies by an excessive accumulated blunting of the rod pyramid. In addition, it appears that viscous effects and tensile, as well as compressive residual stresses of less than 200 MPa, do not play an important role on the ratchetting rate. However, load amplitude and maximum load are important. Phenomenological relationship describing this evolution is established.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Study of Ratchetting During Indentation of 316L Stainless Steel
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812346
dc.journal.fristpage218
dc.journal.lastpage223
dc.identifier.eissn1528-8889
dc.keywordsStainless steel
dc.keywordsStress
dc.keywordsFatigue
dc.keywordsSurgery
dc.keywordsCycles
dc.keywordsJunctions
dc.keywordsRods
dc.keywordsShearing
dc.keywordsScrews
dc.keywordsResidual stresses
dc.keywordsForce
dc.keywordsDeformation
dc.keywordsClearances (Engineering) AND Prostheses
dc.treeJournal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record