Show simple item record

dc.contributor.authorG. C. Butler
dc.contributor.authorS. R. Stock
dc.contributor.authorV. C. Ferney
dc.contributor.authorS. Graham
dc.contributor.authorD. L. McDowell
dc.date.accessioned2017-05-08T23:56:44Z
dc.date.available2017-05-08T23:56:44Z
dc.date.copyrightJuly, 1998
dc.date.issued1998
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26992#197_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120511
dc.description.abstractThe extended Taylor assumption of uniform deformation gradient among grains was applied in 3-D polycrystal plasticity simulations for complex loading paths at finite strain for OFHC Cu using the Los Alamos polycrystal plasticity (LApp) code (Kocks et al., 1994). Comparisons of both stress-strain behavior and texture evolution, with and without the inclusion of latent hardening effects, show that the theory overpredicts the rate of development of texture in both torsion and compression. Compression stress-strain behavior was accurately predicted, but the effect of the prestrain, either compressive or torsional, on subsequent nonproportional deformation response was inadequately modeled. Some possible sources of the discrepancies are discussed, including the low order nature of the extended Taylor model for intergranular interactions as compared to self-consistent models, low order formulation of slip system hardening, lack of accounting for formation of dislocation substructure within grains, and the possible role of anisotropic elasticity. Deformation-induced anisotropy and accommodation of intergranular constraint afforded by geometrically necessary dislocation substructure formation is viewed as the key neglected element of the formulation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleApplication of the Taylor Polycrystal Plasticity Model to Complex Deformation Experiments
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812342
dc.journal.fristpage197
dc.journal.lastpage205
dc.identifier.eissn1528-8889
dc.keywordsPlasticity
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsHardening
dc.keywordsTexture (Materials)
dc.keywordsCompression
dc.keywordsDislocations
dc.keywordsGradients
dc.keywordsEngineering simulation
dc.keywordsAnisotropy
dc.keywordsTorsion AND Elasticity
dc.treeJournal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record