| dc.contributor.author | Liyong Tong | |
| dc.date.accessioned | 2017-05-08T23:56:43Z | |
| dc.date.available | 2017-05-08T23:56:43Z | |
| dc.date.copyright | October, 1998 | |
| dc.date.issued | 1998 | |
| dc.identifier.issn | 0094-4289 | |
| dc.identifier.other | JEMTA8-26994#300_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/120505 | |
| dc.description.abstract | It was experimentally shown that transverse stitching can provide an over 20 percent improvement in the strength of composite single-lap joints manufactured using the Resin Transfer Moulding (RTM) process. In this study, an analytical model is presented to predict the strength of the RTM single-lap joints with and without transverse stitching. Simple formulas are used to calculate the energy release rates of mode I and II using longitudinal membrane force and bending moment in a continuous adherent at an overlap end. The strengths of single-lap joints are determined using an interactive mixed-mode based failure criterion. A good correlation between the measured and the predicted failure loads validates the present analytical model. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Strength Prediction of RTM Single-Lap Joints With Transverse Stitching | |
| dc.type | Journal Paper | |
| dc.journal.volume | 120 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Engineering Materials and Technology | |
| dc.identifier.doi | 10.1115/1.2807018 | |
| dc.journal.fristpage | 300 | |
| dc.journal.lastpage | 303 | |
| dc.identifier.eissn | 1528-8889 | |
| dc.keywords | Force | |
| dc.keywords | Composite materials | |
| dc.keywords | Stress | |
| dc.keywords | Failure | |
| dc.keywords | Formulas | |
| dc.keywords | Membranes | |
| dc.keywords | Resins AND Transfer molding | |
| dc.tree | Journal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 004 | |
| dc.contenttype | Fulltext | |