Show simple item record

dc.contributor.authorZone-Ching Lin
dc.contributor.authorYan-Liang Zheng
dc.date.accessioned2017-05-08T23:56:42Z
dc.date.available2017-05-08T23:56:42Z
dc.date.copyrightOctober, 1998
dc.date.issued1998
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26994#265_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120496
dc.description.abstractThis paper used large deformation finite element theory, updated Lagrangian formulation, finite difference method, and incremental theory to develop a three-dimensional thermo-elastic-plastic simulation model for a tool with chip breaker. Both the critical strain energy density theory and the tool feed geometrical location were introduced as the chip separation criterion for cutting. The algorithm of tool movement geometrical limitations was used to examine and correctly the node so as to conform to real cutting conditions. In this model, the tool moved step by step in the simulation, which ran from the initial contact between tool and workpiece to the formation of steady cutting force. Finally, the numerical simulation model proposed in this paper was used to analyze the changes in workpiece and chip shapes, stress, strain rate, residual stress, temperature and cutting force of mild steel workpiece under different chip breaker lengths. The results were also compared with those from tools without chip breaker. The findings indicate that the chip breaker length affects the shorter the chip breaker length, the better the effects of chip breaker, and the lower the values of the aforementioned physical properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStudy on the Thermo-Elastic-Plastic Cutting Model for 3-D Tool with Chip Breaker
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2807011
dc.journal.fristpage265
dc.journal.lastpage274
dc.identifier.eissn1528-8889
dc.keywordsCutting
dc.keywordsForce
dc.keywordsStress
dc.keywordsAlgorithms
dc.keywordsEquipment and tools
dc.keywordsFinite element analysis
dc.keywordsDeformation
dc.keywordsTemperature
dc.keywordsSeparation (Technology)
dc.keywordsSteel
dc.keywordsComputer simulation
dc.keywordsSimulation
dc.keywordsFinite difference methods
dc.keywordsShapes
dc.keywordsSimulation models AND Density
dc.treeJournal of Engineering Materials and Technology:;1998:;volume( 120 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record