Show simple item record

dc.contributor.authorG. Lackner
dc.contributor.authorF. J. S. Alhanati
dc.contributor.authorS. A. Shirazi
dc.contributor.authorD. R. Doty
dc.contributor.authorZ. Schmidt
dc.date.accessioned2017-05-08T23:56:26Z
dc.date.available2017-05-08T23:56:26Z
dc.date.copyrightMarch, 1998
dc.date.issued1998
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26475#41_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120342
dc.description.abstractThe presence of free gas at the pump intake adversely affects the performance of an electrical submersible pump (ESP) system, often resulting in low efficiency and causing operational problems. One method of reducing the amount of free gas that the pump has to process is to install a rotary gas separator. The gas-liquid flow associated with the down hole installation of a rotary separator has been investigated to address its overall phase segregation performance. A mathematical model was developed to investigate factors contributing to gas-liquid separation and to determine the efficiency of the separator. The drift-flux approach was used to formulate this complex two-phase flow problem. The turbulent diffusivity was modeled by a two-layer mixing-length model and the relative velocity between phases was formulated based on published correlations for flows with similar characteristics. The well-known numerical procedure of Patankar-Spalding for single-phase flow computations was extended to this two-phase flow situation. Special discretization techniques were developed to obtain consistent results. Special under relaxation procedures were also developed to keep the gas void fraction in the interval [0, 1]. Predicted mixture velocity vectors and gas void fraction distribution for the two-phase flow inside the centrifuge are presented. The model’s predictions are compared to data gathered on a field scale experimental facility to support its invaluable capabilities as a design tool for ESP installations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Simulation of the Gas-Liquid Flow in a Rotary Gas Separator
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2795008
dc.journal.fristpage41
dc.journal.lastpage48
dc.identifier.eissn1528-8994
dc.keywordsFlow (Dynamics)
dc.keywordsComputer simulation
dc.keywordsPumps
dc.keywordsTwo-phase flow
dc.keywordsPorosity
dc.keywordsSubmersibles
dc.keywordsComputation
dc.keywordsMixtures
dc.keywordsRelaxation (Physics)
dc.keywordsDesign
dc.keywordsSeparation (Technology) AND Turbulence
dc.treeJournal of Energy Resources Technology:;1998:;volume( 120 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record