Show simple item record

dc.contributor.authorL. L. Hoberock
dc.contributor.authorG. J. Bratcher
dc.date.accessioned2017-05-08T23:56:24Z
dc.date.available2017-05-08T23:56:24Z
dc.date.copyrightJune, 1998
dc.date.issued1998
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26476#118_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120323
dc.description.abstractIn the mathematical modeling of bit penetration rate for tri-cone roller bits in permeable formations, virtually all of the current techniques assume that the differential pressure between the bottom-hole wellbore pressure and the formation is a “static” value. This work shows that the appropriate differential pressure is a dynamic quantity, because for overbalanced drilling, fluid filtrate from the wellbore requires a finite time to flow into the formation, producing a changing pressure gradient ahead of the bit. Moreover, this dynamic gradient is directly dependent upon the rate of drill bit penetration, which is in turn dependent upon the dynamic gradient itself. Accordingly, coupled penetration rate and dynamic gradient equations must be solved, which frequently result in the prediction of higher drilling penetration rates than when the static gradient is used. The appropriate dynamic differential pressure equations are developed and applied to an example drilling situation. It is shown that with water-based drilling fluids, for rock with permeability greater than a few microdarcies at virtually all penetration rates, and for penetration rates less than 3 m/h (9.84 ft/h) at permeabilities greater than 1 μd (microdarcy), the dynamic differential pressure is significantly less than the static differential pressure. Accordingly, using the conventional static differential pressure results in the prediction of penetration rates that are much too low. Moreover, using measured penetration rates from the field, the conventional approach yields predicted in-situ rock strength that is much too high.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Differential Pressure Effects on Drilling of Permeable Formations
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2795021
dc.journal.fristpage118
dc.journal.lastpage123
dc.identifier.eissn1528-8994
dc.keywordsPressure
dc.keywordsDrilling
dc.keywordsGradients
dc.keywordsFluids
dc.keywordsPermeability
dc.keywordsRocks
dc.keywordsEquations
dc.keywordsRollers
dc.keywordsWater
dc.keywordsFlow (Dynamics)
dc.keywordsPressure gradient
dc.keywordsBits (Tools) AND Modeling
dc.treeJournal of Energy Resources Technology:;1998:;volume( 120 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record