Show simple item record

dc.contributor.authorA. K. Wojtanowicz
dc.contributor.authorD. Zhou
dc.date.accessioned2017-05-08T23:56:24Z
dc.date.available2017-05-08T23:56:24Z
dc.date.copyrightJune, 1998
dc.date.issued1998
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26476#111_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120322
dc.description.abstractThis paper presents the results of a theoretical study, supported with the finite element analysis, into potential loss of external integrity around a casing shoe resulting from leak-off testing (LOT) in upper marine sediments (UMS). Three types of possible failures from LOTs were considered: vertical fracture, horizontal fracture, and a channel outside cemented annulus. It is proved in the paper that vertical fracture is the most unlikely failure of the three. The other two types of failure can be distinguished by different values of propagation pressures. Although horizontal fractures are initiated at low pressure in the plastic zone around the wellbore, they cannot propagate beyond the plastic zone until wellbore pressures exceed overburden pressures. Annular channels, on the other hand, may propagate upwards at pressures lower than overburden pressure. The paper shows that these channels are initiated at pressures equal to the contact stress between cement and rock and their propagation pressures are on average 3.5-fold greater than contact stress. It is also explained how to identify the UMS with high risk of annular channeling during LOTs.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBorehole Failure Resulting From Formation Integrity (Leak-Off) Testing in Upper Marine Sediments Offshore
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2795020
dc.journal.fristpage111
dc.journal.lastpage117
dc.identifier.eissn1528-8994
dc.keywordsOcean engineering
dc.keywordsTesting
dc.keywordsFailure
dc.keywordsSediments
dc.keywordsLeakage
dc.keywordsFracture (Process)
dc.keywordsChannels (Hydraulic engineering)
dc.keywordsStress
dc.keywordsPressure
dc.keywordsAnnulus
dc.keywordsCements (Adhesives)
dc.keywordsFinite element analysis AND Rocks
dc.treeJournal of Energy Resources Technology:;1998:;volume( 120 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record