Show simple item record

dc.contributor.authorA. C. Seibi
dc.contributor.authorA. M. Al-Shabibi
dc.date.accessioned2017-05-08T23:56:21Z
dc.date.available2017-05-08T23:56:21Z
dc.date.copyrightDecember, 1998
dc.date.issued1998
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26479#263_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120300
dc.description.abstractThe present paper describes the running process in horizontal wells and studies the effect of some factors on running forces required to push pipes through curved holes with short to medium radii of curvatures. Estimation of the running forces was performed using a general-purpose finite element program called ANSYS. The effect of pipe bending stiffness, hole radius of curvature, and hole clearance are investigated. Finite element results showed that the pipe bending stiffness becomes insignificant for medium curvatures (i.e., radius of curvature greater than 80 m). It was also found that the running force at the kick-off point (k.o.p) increases as the radius of curvature shortens (severe doglegs) and as the pipe stiffness increases. In addition, FE results revealed that the effect of hole clearance on the running force is negligible.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePipe Bending and Running Forces in Medium to High-Curvature Wells Using Finite Element Analysis
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2795046
dc.journal.fristpage263
dc.journal.lastpage267
dc.identifier.eissn1528-8994
dc.keywordsForce
dc.keywordsWells
dc.keywordsPipe bending
dc.keywordsFinite element analysis
dc.keywordsStiffness
dc.keywordsPipes AND Clearances (Engineering)
dc.treeJournal of Energy Resources Technology:;1998:;volume( 120 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record