Show simple item record

dc.contributor.authorE. Budak
dc.contributor.authorY. Altintaş
dc.date.accessioned2017-05-08T23:56:10Z
dc.date.available2017-05-08T23:56:10Z
dc.date.copyrightMarch, 1998
dc.date.issued1998
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26245#31_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120210
dc.description.abstractThe general formulation for the milling chatter prediction developed in Part I of the paper is applied to common milling systems. Three cases are considered: a workpiece with single-degree-of-freedom, a face milling cutter with two-degree-of-freedom, and peripheral milling of a cantilevered thin web. The general milling stability formulation is further simplified for the less complicated models. For each case, an analytical expression which explicitly relate the chatter limit to the milling conditions and tool-workpiece dynamics are derived. The analytical predictions are compared with numerical and time domain solutions proposed by previous research. It is shown that the proposed method can accurately predict the chatter limits in milling and thus eliminates the time consuming numerical solutions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalytical Prediction of Chatter Stability in Milling—Part II: Application of the General Formulation to Common Milling Systems
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2801318
dc.journal.fristpage31
dc.journal.lastpage36
dc.identifier.eissn1528-9028
dc.keywordsStability
dc.keywordsChatter
dc.keywordsMilling AND Dynamics (Mechanics)
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1998:;volume( 120 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record