Show simple item record

dc.contributor.authorA. L. Audenino
dc.contributor.authorE. M. Zanetti
dc.contributor.authorP. M. Calderale
dc.date.accessioned2017-05-08T23:56:08Z
dc.date.available2017-05-08T23:56:08Z
dc.date.copyrightJune, 1998
dc.date.issued1998
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26246#177_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/120185
dc.description.abstractWhen a metallic material is highly stressed, its internal specific damping capacity increases showing a nonlinear behavior. In spite of this, the most part of experimental methods employ nonhomogeneous stress fields measuring only a volumetric average, often called structural damping. To overcome this problem the procedure herein presented extends the applicability of the plain traction or compression methods to higher frequency range (up to 300 Hz). The introduced methodology corrects for elastic energy and dissipated energy relative to the test machine and to the fixtures. The experimental procedure is based on the acquisition of a decay signal when the test machine excitation force has been removed. Two different methods to extract the pattern of internal damping versus material strain have been compared: one is based on least square exponential fitting while the other employs an autoregressive model. Best results have been obtained combining the two techniques taking into account also the variation of Young’s modulus with strain. The resulting curves of the loss factor as a function of strain amplitude for three steels and two cast irons are presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAssessment of Internal Damping in Uniaxially Stressed Metals: Exponential and Autoregressive Methods
dc.typeJournal Paper
dc.journal.volume120
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2802407
dc.journal.fristpage177
dc.journal.lastpage184
dc.identifier.eissn1528-9028
dc.keywordsMetals
dc.keywordsDamping
dc.keywordsMachinery
dc.keywordsSteel
dc.keywordsStress
dc.keywordsIrons (Textile pressing)
dc.keywordsJigs and fixtures
dc.keywordsExperimental methods
dc.keywordsCompression
dc.keywordsFittings
dc.keywordsSignals
dc.keywordsTraction
dc.keywordsForce AND Elasticity
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1998:;volume( 120 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record