Show simple item record

dc.contributor.authorW. F. Swinson
dc.contributor.authorR. L. Battiste
dc.contributor.authorG. T. Yahr
dc.date.accessioned2017-05-08T23:54:31Z
dc.date.available2017-05-08T23:54:31Z
dc.date.copyrightMay, 1997
dc.date.issued1997
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28376#207_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/119280
dc.description.abstractIf the load is not relieved as a structure starts to yield, the induced stress is defined as primary stress. If the load relaxes, as a structure begins to yield the induced stress is defined as secondary stress. In design, it is not uncommon to give more weight to primary stresses than to secondary stresses. However, knowing when this is good design practice and when it is not good design practice represents a problem. In particular, the fuel plates in operating reactors contain both primary stresses and secondary stresses, and to properly assess a design there is a need to assign design weights to the stresses. Tests were conducted on reactor fuel plates intended for the advanced neutron source (ANS) to determine the potential of giving different design weights to the primary and secondary stresses. The results of these tests and the conclusion that the stresses should be weighted the same are given in this paper.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Investigation of the Interaction of Primary and Secondary Stresses in Fuel Plates
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842285
dc.journal.fristpage207
dc.journal.lastpage210
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1997:;volume( 119 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record