Show simple item record

dc.contributor.authorJ. Jekerle
dc.date.accessioned2017-05-08T23:54:28Z
dc.date.available2017-05-08T23:54:28Z
dc.date.copyrightAugust, 1997
dc.date.issued1997
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28378#301_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/119250
dc.description.abstractIn the wall of an oval pipe, additional to the circumferential forces, shear forces and bending moments occur under internal pressure load. Under this condition, the bending stresses in certain cross sections reach a figure many times that of normal stresses so that yield strength of the material can be exceeded. The usual stress calculation method is based on the calculation of the bending moments with the use of the elastic bending equation. The use of the part-plastic equation presented in the paper gives more accurate values for the bending moments sought in the cross sections being checked. This paper shows that even though the new calculation method leads to a smaller wall thickness of the flat oval pipe, the design of the flat oval pipe is nevertheless safe.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleProposal for Calculations of Flat Oval Pipes Under Internal Pressure Under Consideration of Material Plastification
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842308
dc.journal.fristpage301
dc.journal.lastpage305
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsPipes
dc.keywordsStress
dc.keywordsCross section (Physics)
dc.keywordsEquations
dc.keywordsForce
dc.keywordsWall thickness
dc.keywordsYield strength
dc.keywordsShear (Mechanics)
dc.keywordsBending (Stress) AND Design
dc.treeJournal of Pressure Vessel Technology:;1997:;volume( 119 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record