Show simple item record

dc.contributor.authorB. P. Sanders
dc.contributor.authorS. Mall
dc.contributor.authorL. B. Dennis
dc.date.accessioned2017-05-08T23:53:37Z
dc.date.available2017-05-08T23:53:37Z
dc.date.copyrightOctober, 1997
dc.date.issued1997
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26988#422_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118766
dc.description.abstractA study was conducted to investigate the fatigue behavior of a cross-ply metal matrix composite subjected to fully-reversed, strain-controlled fatigue cycling at elevated temperature. The stress-strain response, maximum and minimum stresses, and modulus during cycling were analyzed to characterize the macro-mechanical behavior. Additionally, microscopy and fractography were conducted to identify damage mechanisms. Damage always initiated in the 90 deg plies, but the governing factor in the fatigue life was damage in the 0 deg plies. The dominant failure mode was fracturing of fibers in the 0 deg plies when the maximum strain was greater than 0.55 percent, but the dominant failure mode was matrix cracking when the maximum strain was less than 0.55 percent. Combining the fatigue life data with the macro-mechanical and microscopic observations, a fatigue life diagram was developed and partitioned into three regions. These regions showed relationships between the maximum applied strain and the dominant damage mechanisms. Also, on a strain range basis, the fatigue lives of the specimens tested under the strain-controlled mode in this study were compared with its counterpart under the load-controlled mode of the previous study. It was found that the fatigue lives for these two conditions were the same within the experimental scatter.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Behavior of a Cross-Ply Metal Matrix Composite at Elevated Temperature Under the Strain Controlled Mode
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812279
dc.journal.fristpage422
dc.journal.lastpage428
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsTemperature
dc.keywordsMetal matrix composites
dc.keywordsStress
dc.keywordsFatigue life
dc.keywordsFracture (Process)
dc.keywordsFailure
dc.keywordsMechanisms
dc.keywordsMicroscopy
dc.keywordsFractography
dc.keywordsElectromagnetic scattering AND Fibers
dc.treeJournal of Engineering Materials and Technology:;1997:;volume( 119 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record