Show simple item record

dc.contributor.authorHamid Nayeb-Hashemi
dc.contributor.authorOussama Cherkaoui Jawad
dc.date.accessioned2017-05-08T23:53:37Z
dc.date.available2017-05-08T23:53:37Z
dc.date.copyrightOctober, 1997
dc.date.issued1997
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26988#415_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118765
dc.description.abstractReliable applications of adhesively bonded joints require understanding of the stress distribution along the bond-line and the stresses that are responsible for the joint failure. To properly evaluate factors affecting peel strength, effects of defects such as voids on the stress distribution in the overlap region must be understood. In this work, the peel stress distribution in a single lap joint is derived using a strength of materials approach. The bonded joint is modeled as Euler-Bernoulli beams, bonded together with an adhesive, which is modeled as an elastic foundation which can resist both peel and shear stresses. It is found that for certain adhesive and adherend geometries and properties, a central void with the size up to 50 percent of the overlap length has negligible effect on the peak peel and shear stresses. To verify the solutions obtained from the model, the problem is solved again by using the finite element method and by treating the adherends and the adhesive as elastic materials. It is found that the model used in the analysis not only predicts the correct trend for the peel stress distribution but also gives rather surprisingly close results to that of the finite element analysis. It is also found that both shear and peel stresses can be responsible for the joint performance and when a void is introduced, both of these stresses can contribute to the joint failure as the void size increases. Acoustic emission activities of aluminum-adhesive-aluminum specimens with different void sizes were monitored. The AE ringdown counts and energy were very sensitive and decreased significantly with the void size. It was observed that the AE events were shifting towards the edge of the overlap where the maximum peeling and shearing stresses were occurring as the void size increased.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTheoretical and Experimental Evaluation of the Bond Strength Under Peeling Loads
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812278
dc.journal.fristpage415
dc.journal.lastpage421
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsBond strength
dc.keywordsStress concentration
dc.keywordsAdhesives
dc.keywordsShear (Mechanics)
dc.keywordsAluminum
dc.keywordsFailure
dc.keywordsShearing
dc.keywordsAcoustic emissions
dc.keywordsFinite element analysis
dc.keywordsFinite element methods
dc.keywordsProduct quality AND Strength (Materials)
dc.treeJournal of Engineering Materials and Technology:;1997:;volume( 119 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record