Show simple item record

dc.contributor.authorJ. N. Scheuring
dc.contributor.authorA. F. Grandt
dc.date.accessioned2017-05-08T23:53:36Z
dc.date.available2017-05-08T23:53:36Z
dc.date.copyrightOctober, 1997
dc.date.issued1997
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26988#380_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118760
dc.description.abstractThis paper evaluates changes in the behavior of aircraft materials which result from aging and/or corrosion that occurs during long periods of service usage. The primary objective was to determine whether damage tolerant analyses for older aircraft should employ updated properties that more accurately represent the current state of the material, or if the virgin material properties continue to properly characterize the aged/corroded alloy. Specifically, tensile stress-strain curves, cyclic stress life (SN) tests, and fatigue crack growth tests were used to characterize the “aged aircraft” material. These properties were compared with handbook properties for virgin material of the same pedigree. The aluminum alloys tested were obtained from fuselage and wing panels of retired KC-135 aircraft. Computer controlled tests were conducted using specimens machined from the retired aircraft components. Different configurations were used to observe the effects of aging and/or corrosion on material behavior. In the crack growth specimens, various levels of corrosion were observed, thus the crack growth rates could be categorized as a function of the level of corrosion present. The SN and da/dN-ΔK curves for the “aged” only materials were compared with the fatigue properties of virgin material of the same alloy. Similar comparisons were performed for the tensile stress-strain properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMechanical Properties of Aircraft Materials Subjected to Long Periods of Service Usage
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2812273
dc.journal.fristpage380
dc.journal.lastpage386
dc.identifier.eissn1528-8889
dc.keywordsMechanical properties
dc.keywordsAircraft
dc.keywordsCorrosion
dc.keywordsFracture (Materials)
dc.keywordsAlloys
dc.keywordsStress
dc.keywordsStress-strain curves
dc.keywordsAluminum alloys
dc.keywordsMaterials properties
dc.keywordsComputers
dc.keywordsFatigue cracks
dc.keywordsWings AND Fatigue properties
dc.treeJournal of Engineering Materials and Technology:;1997:;volume( 119 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record