Show simple item record

dc.contributor.authorJ. T. Kuo
dc.contributor.authorW.-S. Hsu
dc.contributor.authorT.-C. Yo
dc.date.accessioned2017-05-08T23:53:16Z
dc.date.available2017-05-08T23:53:16Z
dc.date.copyrightJune, 1997
dc.date.issued1997
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26471#120_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118585
dc.description.abstractOne important aspect of refuse mass-burn combustion control is the manipulation of combustion air. Proper air manipulation is key to the achievement of good combustion efficiency and reduction of pollutant emissions. Experiments, using a small fix-grate laboratory furnace with cylindrical combustion chamber, were performed to investigate the influence of undergrate/sidewall air distribution on the combustion of beds of wood cubes. Wood cubes were used as a convenient laboratory surrogate of solid refuse. Specifically, for different bed configurations (e.g., bed height, bed voidage, bed fuel size, etc.), burning rates and combustion temperatures at different bed locations were measured under various air supply and distribution conditions. One of the significant results of the experimental investigation is that combustion, with air injected from side walls and no undergrate air, has the maximum combustion efficiency. On the other hand, combustion with undergrate air achieves higher combustion rates but with higher CO emissions. A simple one-dimensional model was constructed to derive correlation of combustion rate as a function of flue gas temperature and oxygen concentration. Despite the fact that the model is one-dimensional and many detailed chemical and physical processes of combustion are not considered, comparisons of the model predictions and the experimental results indicate that the model is appropriate for quantitative evaluation of bed-burning rates.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Air Distribution on Solid Fuel Bed Combustion
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2794975
dc.journal.fristpage120
dc.journal.lastpage128
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsSolid wastes
dc.keywordsWood products
dc.keywordsTemperature
dc.keywordsEmissions
dc.keywordsCombustion chambers
dc.keywordsFlue gases
dc.keywordsFurnaces
dc.keywordsOxygen
dc.keywordsPollution AND Fireplaces
dc.treeJournal of Energy Resources Technology:;1997:;volume( 119 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record