Show simple item record

dc.contributor.authorA. L. Boehman
dc.contributor.authorJ. W. Simons
dc.contributor.authorS. J. Niksa
dc.contributor.authorJ. G. McCarty
dc.date.accessioned2017-05-08T23:53:15Z
dc.date.available2017-05-08T23:53:15Z
dc.date.copyrightSeptember, 1997
dc.date.issued1997
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26472#164_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118572
dc.description.abstractDynamic stress behavior during catalytic combustion of methane has been simulated under transient warm-up, cool-down, and cyclic conditions. The numerical model combines a two-dimensional solution to the transport equations, solution of an energy balance on the monolith wall, and the NIKE3D structural analysis code to predict thermal stresses. The model also includes a detailed heterogeneous kinetics model for a proprietary palladium oxide (PdO) catalyst, but the model ignores gas-phase reactions. Results illustrate that thermal stresses as high as 630 MPa can form during transient operating modes, which risks structural failure of the ceramic monolith. The maximum computed thermal stress concentrations occur near the inlet of the monolith. Peak transverse stresses (which act to form axial cracks) typically form near the inlet and centerline of the monolith structure, while peak axial stresses form near the edges of the flat plate that represents the monolith structure. Increasing the preheat temperature of the incoming fuel and air mixture lessens the peak thermal stress. To a first approximation, the magnitude of the peak transverse stress during any transient cycle considered with our model can be estimated from the maximum value of the gradient in the computed temperature profiles.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Stress Behavior in Catalytic Combustors
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2794985
dc.journal.fristpage164
dc.journal.lastpage170
dc.identifier.eissn1528-8994
dc.keywordsCombustion chambers
dc.keywordsStress
dc.keywordsThermal stresses
dc.keywordsStructural failures
dc.keywordsTemperature
dc.keywordsCombustion
dc.keywordsStructural analysis
dc.keywordsCeramics
dc.keywordsFuels
dc.keywordsComputer simulation
dc.keywordsEnergy budget (Physics)
dc.keywordsFracture (Materials)
dc.keywordsApproximation
dc.keywordsCatalysts
dc.keywordsCycles
dc.keywordsEquations
dc.keywordsFlat plates
dc.keywordsGradients
dc.keywordsMethane
dc.keywordsMixtures
dc.keywordsPalladium AND Temperature profiles
dc.treeJournal of Energy Resources Technology:;1997:;volume( 119 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record