Show simple item record

dc.contributor.authorH. E. Jenkins
dc.contributor.authorS. J. Ludwick
dc.contributor.authorT. R. Kurfess
dc.date.accessioned2017-05-08T23:52:59Z
dc.date.available2017-05-08T23:52:59Z
dc.date.copyrightJune, 1997
dc.date.issued1997
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26234#289_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118430
dc.description.abstractIn precision abrasive machining, it is important to control process variables such as the material removal rate, normal force and power input, as these factors influence surface finish, dimensional precision, and material damage. In this research, a linear grinding process model, with enhancements over past models, is developed relating normal force to material removal rates. Two experimental procedures for the determination of the grinding model’s parameters are presented. Simulations are performed to validate the grinding model. The determined model is found to be a valid representation of the grinding process that should prove useful in adaptive control with real-time parameter estimation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDetermination of a Dynamic Grinding Model
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2801248
dc.journal.fristpage289
dc.journal.lastpage293
dc.identifier.eissn1528-9028
dc.keywordsGrinding
dc.keywordsForce
dc.keywordsAccuracy
dc.keywordsParameter estimation
dc.keywordsAdaptive control
dc.keywordsFinishes
dc.keywordsAbrasive machining AND Engineering simulation
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1997:;volume( 119 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record