Show simple item record

dc.contributor.authorPiero Azzoni
dc.date.accessioned2017-05-08T23:52:52Z
dc.date.available2017-05-08T23:52:52Z
dc.date.copyrightDecember, 1997
dc.date.issued1997
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26241#614_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/118357
dc.description.abstractKnowledge of the pressure waveform in each cylinder of a spark-ignition engine may provide useful diagnostic information concerning engine operation. This paper presents a method for the reconstruction of the indicated pressure waveform for each cylinder of a multicylinder internal combustion engine using engine block vibration signals. The method permits the reconstruction of the cylinder pressure waveform, cycle by cycle, during free accelerations. The procedure has good potential for application in end-of-assembly diagnostic tests, using a noncontacting laser velocimeter. The same signal processing method may be applicable on-board an automobile to perform an on-line cylinder-by-cylinder diagnostics, using the same vibration sensor used for knock detection in many production vehicles.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleReconstruction of Indicated Pressure Waveform in a Spark-Ignition Engine From Block Vibration Measurements
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue4
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2802369
dc.journal.fristpage614
dc.journal.lastpage619
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1997:;volume( 119 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record