Show simple item record

dc.contributor.authorM. D. Ratiu
dc.contributor.authorN. T. Mosidis
dc.date.accessioned2017-05-08T23:51:24Z
dc.date.available2017-05-08T23:51:24Z
dc.date.copyrightFebruary, 1996
dc.date.issued1996
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28365#42_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117576
dc.description.abstractThe diesel generator exhaust piping, usually made up of carbon steel piping (e.g., ASME SA-106, SA-53), is subjected to successive short time exposures at elevated temperatures up to 1000° F (538°C). A typical design of this piping, without consideration for creep-fatigue cumulative damage, is at least incomplete, if not inappropriate. Also, a design for creep-fatigue, usually employed for long-term exposure to elevated temperatures, would be too conservative and will impose replacement of the carbon steel piping with heat-resistant CrMo alloy piping. The existing ASME standard procedures do not explicitly provide acceptance criteria for the design qualification to withstand these intermittent exposures to elevated temperatures. The serviceability qualification proposed is based on the evaluation of equivalent full temperature cycles which are presumed/expected to be experienced by the exhaust piping during the design operating life of the diesel engine. The proposed serviceability analysis consists of: (a) determination of the permissible stress at elevated temperatures, and (b) estimation of creep-fatigue damage for the total expected cycles of elevated temperature exposures following the procedure provided in ASME Code Cases N-253-6 and N-47-28.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleQualification of Diesel Generator Exhaust Carbon Steel Piping to Intermittent Elevated Temperatures
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842161
dc.journal.fristpage42
dc.journal.lastpage47
dc.identifier.eissn1528-8978
dc.keywordsTemperature
dc.keywordsCarbon steel
dc.keywordsPipes
dc.keywordsExhaust systems
dc.keywordsDiesel generators
dc.keywordsDesign
dc.keywordsCreep
dc.keywordsFatigue
dc.keywordsMaintainability
dc.keywordsASME Standards
dc.keywordsCycles
dc.keywordsDiesel engines
dc.keywordsAcceptance criteria
dc.keywordsService life (Equipment)
dc.keywordsStress
dc.keywordsHeat AND Alloys
dc.treeJournal of Pressure Vessel Technology:;1996:;volume( 118 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record