Show simple item record

dc.contributor.authorY. Ooka
dc.contributor.authorK. Ohno
dc.contributor.authorK. Dozaki
dc.contributor.authorH. Ogawa
dc.date.accessioned2017-05-08T23:51:22Z
dc.date.available2017-05-08T23:51:22Z
dc.date.copyrightMay, 1996
dc.date.issued1996
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28368#129_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117550
dc.description.abstractSimulative analyses of dynamic buckling have been performed for bellows of piping expansion joints for FBR plants using an explicit finite element computer code “RADIOSS.” Deformation modes were well simulated in comparison with the associated test results. As for critical buckling pressures, values obtained in the analyses were about 50 percent higher than test values, and further improvement is needed. This paper presents these analytical results and discussion. The associated test results are also reviewed for the arrangement of validation of the analyses.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSimulative Analyses of Dynamic Buckling of Bellows
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842170
dc.journal.fristpage129
dc.journal.lastpage136
dc.identifier.eissn1528-8978
dc.keywordsBellows (Equipment)
dc.keywordsBuckling
dc.keywordsIndustrial plants
dc.keywordsPipe expansion joints
dc.keywordsFinite element analysis
dc.keywordsComputers AND Deformation
dc.treeJournal of Pressure Vessel Technology:;1996:;volume( 118 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record