| dc.contributor.author | N. Jones | |
| dc.contributor.author | R. S. Birch | |
| dc.date.accessioned | 2017-05-08T23:51:20Z | |
| dc.date.available | 2017-05-08T23:51:20Z | |
| dc.date.copyright | November, 1996 | |
| dc.date.issued | 1996 | |
| dc.identifier.issn | 0094-9930 | |
| dc.identifier.other | JPVTAS-28370#464_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/117522 | |
| dc.description.abstract | This article presents some experimental data recorded from 54 impact tests on pressurized mild steel pipes. The pipes were fully clamped across a span which was ten times the outside pipe diameter of 60 mm. The pipes had a wall thickness of 1.70 mm and were impacted laterally by a rigid wedge indenter at the mid-span and one-quarter-span positions. The impact velocities ranged up to 13.6 m/s and caused large inelastic indentations for the lower values and at higher values a loss of integrity which could occur underneath the indenter and/or at an end support. The critical values for the two failure energies were obtained for a range of internal gas pressures. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Influence of Internal Pressure on the Impact Behavior of Steel Pipelines | |
| dc.type | Journal Paper | |
| dc.journal.volume | 118 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Pressure Vessel Technology | |
| dc.identifier.doi | 10.1115/1.2842215 | |
| dc.journal.fristpage | 464 | |
| dc.journal.lastpage | 471 | |
| dc.identifier.eissn | 1528-8978 | |
| dc.keywords | Pressure | |
| dc.keywords | Steel | |
| dc.keywords | Pipelines | |
| dc.keywords | Pipes | |
| dc.keywords | Failure | |
| dc.keywords | Impact testing | |
| dc.keywords | Wall thickness AND Wedges | |
| dc.tree | Journal of Pressure Vessel Technology:;1996:;volume( 118 ):;issue: 004 | |
| dc.contenttype | Fulltext | |