Show simple item record

dc.contributor.authorJ. H. Underwood
dc.contributor.authorA. P. Parker
dc.contributor.authorD. J. Corrigan
dc.contributor.authorM. J. Audino
dc.date.accessioned2017-05-08T23:51:20Z
dc.date.available2017-05-08T23:51:20Z
dc.date.copyrightNovember, 1996
dc.date.issued1996
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28370#424_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117515
dc.description.abstractSections of cannon tubes with inner radius of 53, 60, and 78 mm were cycled from near zero to 100–300 MPa internal pressure until fatigue failure occurred. The failure locations were along 2-mm holes cut through the cannon wall at a 30-deg angle to the tube axis, for the purpose of evacuating combustion gases from the cannon after firing. The cannons had various amounts of autofrettage by overstraining, including 0, 30, 50, and 100 percent. The amount of overstrain affected both the initiation position of the fatigue crack along the evacuator hole and the measured fatigue life. Increasing the amount of overstrain moved the crack initiation from the tube inner radius toward a mid-wall position and significantly increased fatigue life. Fracture mechanics and solid mechanics-based calculations of fatigue life were performed for comparison with the measured lives. The calculations gave a good description of the measured life, taking account of tube configuration, applied pressure, amount of overstrain, stress concentration of the hole, crack size and shape, material fatigue crack rate behavior and yield strength, and pressure in the hole and on the crack surfaces. As with measured fatigue life, the calculated life was significantly affected by the amount of autofrettage of the tube. The ratio of outer to inner radius of the tube and the presence of pressure in the evacuator hole also had substantial effects on the calculated fatigue life.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Life Measurements and Analysis for Overstrained Tubes With Evacuator Holes
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842208
dc.journal.fristpage424
dc.journal.lastpage428
dc.identifier.eissn1528-8978
dc.keywordsMeasurement
dc.keywordsFatigue life
dc.keywordsPressure
dc.keywordsFracture (Materials)
dc.keywordsArtillery
dc.keywordsAutofrettage
dc.keywordsFatigue failure
dc.keywordsFailure
dc.keywordsFatigue cracks
dc.keywordsFracture mechanics
dc.keywordsFatigue
dc.keywordsCombustion gases
dc.keywordsStress concentration
dc.keywordsFiring (materials)
dc.keywordsShapes AND Yield strength
dc.treeJournal of Pressure Vessel Technology:;1996:;volume( 118 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record